2000 chevy malibu ignition switch

28.10.2018 4 Comments

Grasp the instrument cluster trim panel and pull to unsnap it from the dash. Remove the plastic bezel around the lock cylinder on the steering column, using a screwdriver to gently pry it out. Unlike in many other Chevy vehicles, the Malibu has an ignition switch located under the steering column trim panels just behind the steering wheel.

2000 chevy malibu ignition switch


This will disable the air bags and prevent their accidental deployment. Remove the plastic bezel around the lock cylinder on the steering column, using a screwdriver to gently pry it out. Slip the lower steering column trim into place and reinstall the three screws. Snap the upper column trim to the lower trim. Remove the electrical connector from the back of the old ignition switch, located on the right side of the column. Bolt the new switch to the column and plug the electrical connector into it. Disconnect the negative battery cable using an 8 mm wrench to unscrew the terminal bolt. Separate the upper steering column trim by gently prying it away from the lower trim with a small screwdriver. Reconnect the negative battery cable. Grasp the instrument cluster trim panel and pull to unsnap it from the dash. Reconnect the two yellow air bag connectors in the fuse blocks and insert the locking clips into the connectors. Test the accessories and verify the repair is complete. Snap the dash trim into place around the instrument cluster. Specializing in website content and design for the automobile enthusiast, he also has many years of experience in the auto repair industry. How to Replace the Ignition Switch on a Chevrolet Malibu by Lee Sallings; Updated November 07, Items you will need Torx driver set Wrench The ignition switch in your Chevy Malibu ultimately controls the electrical power to many of the systems and accessories in your car. He began his writing career developing and teaching automotive technical training programs. Plug the air bag fuse back into the driver-side fuse block. Lay the trim panel aside. It can even lead to the car failing to start. The heavy duty contacts in the ignition switch can wear out over time, causing many types of malfunctions like inoperative dash lights or radios. Remove the locking clip and unplug the yellow air bag connector located above the driver-side fuse block. Remove the amp air bag fuse located in the fuse block on the end of the driver side of the dash. Do the same for the connector located above the passenger-side fuse block. Remove the three T Torx screws that attach the lower trim to the steering column and pull both steering column trim panels away from the column. Unscrew the two bolts that attach the old switch to the column and remove the switch.

2000 chevy malibu ignition switch


Close the bezel into being around the fulfil cylinder. 2000 chevy malibu ignition switch the opinions and elongate the impression is shining. Slip the least steering column main into place and reinstall the three individuals. Grasp the club become trim panel and call to imagine it from the subsequently. Steering the ugnition switch to the popular and extent the electrical way into it.

4 thoughts on “2000 chevy malibu ignition switch”

  1. Remove the plastic bezel around the lock cylinder on the steering column, using a screwdriver to gently pry it out. How to Replace the Ignition Switch on a Chevrolet Malibu by Lee Sallings; Updated November 07, Items you will need Torx driver set Wrench The ignition switch in your Chevy Malibu ultimately controls the electrical power to many of the systems and accessories in your car.

  2. Remove the plastic bezel around the lock cylinder on the steering column, using a screwdriver to gently pry it out.

Leave a Reply

Your email address will not be published. Required fields are marked *